|Configuration (NL4)||1×12″, 1×3″ diaphragm / 2″ exit|
|Internal Crossover Point||1.8kHz|
|Frequency Response (+/-3 dB)||50Hz – 19.5kHz|
|Power Handling (watts)||800 watts|
|SPL & Sensitivity (1w/1m)||131dB / 100dB|
|Nominal Beam Width (degrees)||60 x 90 (Can be rotated)|
|Nominal Impedance – Bi-amp||LF-8ohm, HF-8ohm|
|Nominal Impedance – Passive||Passive 8 ohm|
|Dimensions (HxWxD)||23.34″ x 17.40″ x 15.94″|
|Net Weight & Material||63lbs – 3/4″ plywood|
|Hanging Hardware||8mm shouldered eye bolts & brackets|
|Special Features||Bi-amp/passive switch & pole mount|
T-112 (500 series) 2 channel amplifier module
When installing the amplifier pack, remove the passive panel on the back of the enclosure by un-screwing the t-nut bolts. Once the passive panel has been removed, connect the amplifier by following the simple color coded diagram provided. Once the amplifier has been properly connected, slide the amplifier module into the enclosure and secure with the t-nut bolts.
T-112 AMPLIFER CHANNELS
Amplifier Channel One: When installed into a T-112, amp channel one will power that loudspeaker along with a second non-powered loudspeaker. To power the second loudspeaker, connect the NL4 from the powered cabinet’s “Output 1″ to the non-powered cabinet’s “Input”. This creates a 4 ohm on amp channel one.
Amplifier Channel Two: Amplifier channel two is wired directly to NL4 “Output 2″ on the rear panel of the speaker cabinet. “Output 2″ is only used when an internal power amplifier is installed into the cabinet for this model. Users have multiple options on powering additional T-Series cabinets with “Output 2″. See the diagrams below.
**Note: The amplifier will be pre-tuned to a chambered flat response curve that is specific, per channel, for the models it will be used with. Users can make DSP, gain, delay and other adjustments through the amplifier control software, “TVi Control.” Each amplifier has a single signal input / output, so gain and DSP adjustments between channels must be adjusted and stored within the amplifier’s control software that can be accessed easily with a laptop computer.
A single internal amplifier powering four T-112 loudspeakers: two per channel at a four ohm load per channel.
A single internal amplifier powering two T-112 loudspeakers on channel one & two T-118 subwoofers on channel two at a 4 ohm load per channel.
**Note: Each amplifier channel may also operate at an 8 ohm load, so the diagrams above only show the maximum number of T-Series cabinets that can be powered using a single internal amplifier. Each user’s application is different and may require fewer cabinets per amplifier channel.