Steel Hardware for safe 10:1 load factor.
TVi's premium road tough coating.
Quick Release Pin connections for quick and easy angle adjustments.
Splay angles adjustable from 0-10 degrees.
Ergonomic handles
Logo stamped mesh steel grill.
Each Element Contains:
Two 10” Low-Mid Frequency Woofers.
Each Element Contains:
One 3” titanium diaphragm HF compression driver.
Matching C-218-10 Subwoofer.
specifications c-210ii
Tri amp configuration (NL8) 2×10″, 1×3″ diaphragm
Frequency Response (+/-3 dB) 70 Hz – 19 kHz
Program Power (watts) LF-600, LF2-600, HF-200
RMS Power (watts) LF-300, LF2-300, HF-100
SPL & Sensitivity (1w/1m) 136dB / 110dB
Coverage Angle 100 x 10 degrees
Nominal Impedance LF-8ohm, LF2-8ohm, HF-8ohm
Dimensions (HxWxD) 31.49″ x 17.51″ x 11.81/9.05″
Weight & Material 103 lbs 3/4″ birch plywood

C-210ii Amplification

C-210ii-(500 series) 3 channel amplifier module
(Designed to power two C-210ii enclosures in tri-amp)

A single three channel “ICE” powered class D amplifier module can power one or two C-210ii line array enclosures in tri-amp mode. Amplifier channel one has been designed to power the low frequency, channel two powers the mid frequency and channel three powers the high frequency of one or two enclosures. When powering one C-210ii enclosure it is an 8 ohm load for each channel. When powering two C-210ii enclosures it is a 4 ohm load for each channel. The amplifier module has been designed to fit securely into the enclosure and offers the ability of powering itself plus one additional non-powered C-210ii by linking an NL8 connector cable. Each amplifier is powered by multiple “ICE” power modules and offers an integrated active crossover system along with DSP correction that has been fine tuned in an anechoic chamber to provide the user with chambered flat response.

  • Powered using multiple “ICE” power modules
  • Ultra light weight digital switching technology (8 lbs)
  • Built in DSP correction software
  • Built in digital crossovers to optimize power and clarity
  • Chamber tuned for suggested phasing a flat response correction
  • Durable and heat resistant design to eliminate pre-mature thermal protection
  • Non-powered enclosures are connected to powered enclosure with NL8 patch cables
  • Linkable “Neutrik Power-con” connection capable of 110v or 220v
Installation Process

When installing the amplifier pack, remove the passive panel on the back of the enclosure by un-screwing the t-nut bolts. Once the passive panel has been removed, connect the amplifier by following the simple color coded diagram provided. Once the amplifier has been properly connected, slide the amplifier module into the enclosure and secure with the t-nut bolts.

Link the second non-powered C-210ii to the first with standard NL8 patch cable. Amplifiersare powered by a linkable “Neutrik Power-con” connection and capable of 110v or 220v. Amplifiers ordered for a specific voltage must me slightly modified when changing voltage. Please contact a TVi reprehensive for more information about this. Please see the data sheets for more detailed information on this amplification.