· Hand build with premium grade three quarter inch Birch plywood construction
· High quality Duratek painted finish for durability
· Water & heat resistant coating for indoor/outdoor use
· Extra thick well placed baffling for acoustic efficiency
· Total weight of each unit is 42 lbs non powered
· Removable passive panel where a TVi power module can be inserted later
Components
· U.S designed and custom build specifically to match the line array element
· 350 Watts RMS per line array element
· Single 10” LF/MF driver rated at 300 watts RMS pink noise
· Single 1.7” high energy compression driver rated at 65 watts RMS pink noise
· Recommend crossover points (120 Hz LF/MF, 2.5KHz MF/HF)
Wiring
· Hand soldered 14 gauge copper wiring
· Built in switch to choose from using internal crossover or bi-amp mode
· Parallel NL4 connector cables (Passive mode+1/-1) (Bi-amp mode +1/-1 LF, +2/-2 HF)
· Wired 8 ohms in passive mode and 16 ohms HF/LF in bi-amp mode
· Power amplifier modules are available and will mount inside of a passive element
Hardware
· Pull tested at a 7:1 load factor, 12 units per side
· Built with two layers of steel, double thickness and powder coated black
· Built with bolt-on hardware that mounts to internal steel plates for superb strength
· Steel sliding link bars that connect multiple units in an array and to the fly bars
· Square steel fly bar with shackle slots for hanging
· Multi angle splay points with up to 6 degrees of splay per line array element
Our Service
· Two year limited warranty/service plan
· Reliable and timely service department
· Replacement drivers always available for next day shipping through our service department
