|
T-115m
Loud speaker/Monitor
| RMS Power (per element) |
300 RMS passive |
| |
|
| Line Array Element Configuration |
1x15" woofer & 1.5" compression driver |
| |
|
| Sound Pressure Level (1w/1m) |
122dB |
| |
|
| Sensitivity Level |
97dB |
| |
|
| Frequency Response (+/- 3dB) |
50Hz-18KHz |
| |
|
| Dispersion (Verticle/Horizontal) |
60x90 degrees/switchable to 90x60 by rotating horn |
| |
|
| Weight & Dimensions |
66.1 lbs & 19.5" x 27" x 15.5" |
| |
|
| Component (Passive & HF/LF) |
8 ohm passive mode only |
| |
|
| Connectors (Input/Output) |
Parallel NL4 |
| |
|
| Hardware (Tested at a 7:1 load factor) |
Pole mountable/12 built in hanging points |
| |
|
| Optional Power Module (Estimated amp draw) |
N/A |
| |
|
| Optional Flight Case |
Standard 2 units per flight case |
| |
|
Construction
· Hand build with premium grade ¾ inch Birch plywood construction
· Doubles over as a multi angle floor monitor wedge
· High quality Duratek painted finish for durability
· Water & heat resistant coating for indoor/outdoor use
· Extra thick well placed baffling for acoustic efficiency
· Total weight of each unit is 66 lbs non powered
· The dimensions are Vertical (27 ") Horizontal (19.5”) Width (15.5”)
Components
· Custom build specifically to match the T-115m unit
· 300 Watts RMS per unit, 600 watts program
· Single 15” LF/MF drivers rated at 250 watts RMS each
· Single 1.5” high energy compression driver rated at 65 watts RMS
· Recommend crossover point when adding sub woofers (100-120Hz)
Wiring
· Hand soldered 14 gauge copper wiring
· Parallel NL4 connector cables
· Wired 8 ohms in passive mode with build in crossover to separate the LF & HF
Hardware
· Built in pole mount bracket for versatility
· 12 built in steel enforced fly points for hanging applications |
